ACE1 6km Grafische TDR met software 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 Bestel The add to cart button will appear once you select the values above Detail Kenmerk Specificatie Content Optie Prijs Detail The ACE1 is a hand held Time Domain Reflectometer weighing only 350 grams with a 6km range and the capacity to store 50 traces with time, date, Vp value, impedance, cursor position and range, saved data may then be downloaded to PC via the USB link using Trace Xtra PC software provided. Historical data may be uploaded to the ACE1 for comparison with current measurements. With a 3 nano second pulse rise time giving a dead zone of only 0.5 mtrs near end and cable faults can be clearly identified. Using pre determined gain and pulse width and with only 5 control buttons, all major operating and setting parameters can be easily accessed. A 6km cable run can be scanned in seconds allowing the operator a view of this cable run, yet arriving quickly to the fault. By using the scan lock facility, the cable can be continuously scanned for the location of intermittent faults or the trace held for closer examination. To enable the ACE1 to test all metallic cables, 4 user selectable impedance settings are provided, 25, 50, 75 and 100 ohms with Vp settings of 1-99% or the equivalent in feet or meters per micro second. Faulty cables may be traced using the warble tone feature, an oscillating tone is injected into the power or transmission line and by using a comerically available tone tracing probe, the suspect line can be identified, for this function an optional receiver is required. The ACE1 is CE approved and is housed in a rugged ABS enclosure rated to IP54. Kenmerk USB 2.0 Interface with a Windows compatible software TraceXtra to download/analyse traces Rugged Palm-Top design Weighs less than 350g 11 Measurement Ranges up to 6000m(6km) 25, 50, 75 & 100 Ohm Selectable Cable Impedance Memory capacity up to 50 saved traces Built in Tone Generator for Pair Tracing and Identification Suitable for testing all Communication and Power Cables Environmental Protection IP54 Specificatie Length: 6km Impedance: 25, 50, 75 & 100 Ω Dead zone: 0.5 m Ranges Meters Kilometers: 7, 15, 30, 60, 120, 250, 500, 1km, 2km, 3km, 6km Range step: 11 Accuracy: 1% of selected range* Resolution: 1% of range Range selection: Manual Sensitivity: Min 3 pixel return at 4km on 0.6mm Ø, PE, TP Output Pulse Width: 3 ns to 3 ms, connected to range setting NVP VoP Velocity Factor: Adjustable from 1% to 99% Scan Rate: 2 scans / second or scan held (not on 3km/6km range) Output Pulse: 5 volts peak to peak. Into open circuit PC software: Yes Memory capacity: 50 Traces Tone Generator: 810 - 1100Hz Connector: 2x Banana chassis USB Display: 64 x 128 pixel Backlight: Yes Voltage Protection: 250 volts AC Battery Life: 60 hours continuous scanning Power Supply: 6 volts 4 x 1.5 AA Alkaline cell Power Down: Selectable 1, 2, 3, 5 minutes or disabled Operating Temperature: -10° / 50°C Storage Temperature: -20° / 70°C Dimensions: 165 x 90 x 37 mm Weight 350 grams Standards: IEC 61010-1 EN 60950 ISO9001 EMC: BS/EN 61326-1 Water/Dust Proof: IP54 Goedkeuring: CE, RoHS en WEEE * Measurement accuracy of <+/- 1% assumes the instrument setting for velocity of propergation (Vp) of the cable under test to be accurately set, homogeneity of the Vp along the cable length, and accurate cursor positioning. Content - Main unit - AJJ3 Banaan naar krokodilbek ACE0/ACE1/ACE2 - AJJ4 Tas ACE0/ACE1/ACE2/GT21/GT22 - AJJ6 USB Kabel ACE1 - AJJ7 CD Software en Engels gebruiksaanwijzing ACE1 Optie - CU03 Cursus analoge telefonie en ondergrondse netwerken - KO10 Instrumentkoffer medium (105 mm) - ON80 Ontvanger 9001 Prijs {product}164|quantityfield|pricedis3|pricetax1{/product} Prijzen zijn per stuk, exclusief 21% BTW en gelden voor levering af magazijn Voorthuizen. Bij levering in Nederland of in België worden verzendkosten altijd in rekening gebracht tot maximaal EUR 25,00. Ditzelfde geldt voor expreskosten en/of rembourskosten. Bij de producten trainingen en cursussen is na het bevestigen van de cursusdatum, bij het niet verschijnen van de deelnemer(s), de verplichting ontstaan tot volledige betaling. Het volgen op een latere datum ingeval van niet verschijnen is in overleg mogelijk, maar wordt uitsluitend gezien als service. Hieruit kan geen enkel recht uit worden onttrokken.