The ACZ6 is a new way of
measuring the Cold Cranking Amps (CCA) of a car
battery and it test a wide variety of 12V
batteries: Wet (Flooded), VRLA or Maintenance
Free (MF), Sealed Maintenance Free (SMF),
Absorption Glass Mat (AGM) and GEL cell. It is a
new way of measuring the Cold Cranking Amps (CCA)
of a Starting Battery and it test a wide variety
of 12V batteries: Wet (Flooded), VRLA or
Maintenance Free (MF), Sealed Maintenance Free (SMF),
Absorption Glass Mat (AGM) and GEL cell.
The ACZ6 uses the battery
internal resistance gathered during testing to
compute the final results of the battery
condition. This process involve by a series of
shorting pulse across the battery terminals with
resulting drop in the voltage being measured by
the microprocessors to compute its final
a. Test results on
battery conditions: Either Good or Replace
Battery state of charge: Digital display in
c. Keying in of battery rating (CCA, DIN,
EN, IEC, JIS) before test to determine the life
d. Battery cell resistance
measurement: Display in m ohm
e. Battery Life
Expectancy: Display in percentage (%).
1. Intelligent > It detects and removes surface
charge if any, before proceeding to perform
tests for better results.
2. Accurate > Consistent and accurate test
3. Fast > It takes less than 3 seconds to obtain
not only the values but result summary
4. Direct > Testing is done on the battery
whether it is on or off the vehicle. Also able
to test discharged or weak batteries.
5. Safe> It does not create spark during
clamping or wrong connection to the battery
while performing tests.
6. Maintenance Free > No internal batteries
required. It powers up when connected to the
battery posts during testing. And it never
discharges or drain the battery.
The operation is fast and simple. When hooked up
to the battery posts, the displayed instructions
on the screen will lead you through to perform
the correct steps.
In the event that you need assistance, the
"HELP" key will display information about each
function when selected.